Magnetic Tensioner Instructions for Use

Magnetic Tensioner Instructions for Use:

1. The principle of the magnetic tensioner is to generate damping through the magnetic field conversion torque change, without mechanical friction.

2. Select the appropriate magnetic tensioner of our company according to the diameter of the wire used by the user.

3. Introduction to the main components of the tensioner.

1. The anti-tension knob is used to adjust the angle of the tension rod

2. The micro switch is a device used to detect disconnection alarms. Users can install them according to their needs.

3. The damper is the component that generates the main force

4. The wool ring is used to filter the enameled wire

5. The adjustment dial is marked with a scale. The larger the adjustment scale, the greater the output tension.

Preparations before starting:

1. Anti-tension scale, the adjustment dial scale is at 0 position

2. The wool loop is relaxed, and the tightness of the wool loop is adjusted according to the tension of use.

The small tension loop relaxes, the high tension loop compresses

Open the cylinder, start up for debugging

When the scale of the rotary adjustment dial increases, the output tension will also increase. At the same time, the angle of the tension rod will gradually decrease. The tension rod is in the red warning mark, which is the best debugging position. If it is lower than the mark, the anti-tension knob will turn to the left.

Note: In the debugging process, only the tension scale is allowed to be adjusted from small to large, and it is not allowed to adjust from large to small, otherwise there will be wire breakage. If the tension scale is adjusted from large to small, it must be adjusted in the stopped state

No oil can be added to the damping wheel

The user can adjust the required tension in this way

If the output tension needs to be accurate, please use it with the tension meter. The above is the debugging method of the magnetic tensioner

(Turn off, adjust the tension down)

Abnormal phenomena may occur during use Adjustment methods

1. There are two ways to deal with the slippage of the damping wheel during work. One is to properly clamp the wool ring, and the other is to use a thin cotton thread with alcohol to wipe the 0-ring of the wire wheel.

2. When the angle of the tension rod is higher than the red mark, the tensioner will be abnormally worn. There are two ways to deal with it. One is to rotate the adjustment dial to make the tension increase so that the tension rod slowly goes down, or reverse the tension knob to the direction. Rotate left to bring the tension rod down slowly; the tension rod is as horizontal as possible.

3. When the angle of the tension rod is lower than the red mark position, the anti-tension knob is rotated to the left, and the position of the tension rod is slowly upward, so that the tension rod is as horizontal as possible

4. What should I do if tension pulsation occurs during the debugging process? When the machine is stopped, first slowly turn the scale of the adjusting dial to the maximum scale, and then return to the vicinity of the required tension scale for re-adjustment. If the tension adjustment is still invalid after repeated adjustment, please confirm whether the selected tensioner model is correct.